Enzotech BMR-C1
Forged Copper RAM heatsinks
Date reviewed: March 14th, 2010
Author: Chris
To install the BMR-C1's I opted for the pre-applied thermal adhesive, after cleaning the surface of the memory with Isopropyl alcohol I placed the sink over the memory and applied pressure for about 10 seconds. And the sinks remained attached no problem. Here are a few shots with the BMR-C1's attached to my card.
|
|
Here I have some pics with the HR-03 GT installed and we can see where those modded BMR-C1's fit snugly below the heatpipes.
|
|
Now since I already have overclocked my RAM on the HD 4890 to 1220Mhz there isn't much more I want to try to get here, even by using these RAM sinks. But when I benchmarked the card the BMR-C1's would get very hot, meaning they are transfering heat very efficiently.
Pros: